Description

Simpson Strong-Tie SET3G22-N High-Strength Epoxy Adhesive – 22oz Tube w/ Nozzle

SET-3G is the latest innovation in epoxy anchoring adhesives with high design strength and proven performance. SET-3G is a 1:1 ratio, two-component, anchoring adhesive for concrete (cracked and uncracked). SET-3G installs and performs in a variety of environmental conditions and temperature extremes.

Key Features

• Exceptional performance superior bond strengths permit ductile solutions in high seismic areas
• Design flexibility improved sustained load performance at elevated temperature
• Jobsite versatility can be specified for all base material conditions when in-service temperatures range from -40F (-40C) to 176F (80C)
• Recognized per ICC ES AC308 for post-installed rebar development and splice length design provisions
• Code listed for installation with the Speed Clean DXS, dustless drilling system without further hole cleaning
• Wire brush hole-cleaning system for conventional blow-brush-blow cleaning method for anchoring
• With higher bond strengths, ductile solutions can often be achieved with SET-3G in high seismic areas
• Low-odor formulation
• Manufactured in the USA using global materials
• During the installation of SET-3G, when the correct installation processes are followed, there is no performance difference between water-saturated concrete, water-filled holes, or submerged concrete
• For use with potable water

Applications

• Threaded rod anchor and rebar dowel installations in cracked and uncracked concrete under a wide variety of environmental installation and use conditions
• Installation in downward, horizontal and upwardly inclined (including overhead) orientations
• Qualified for use in structures assigned to Seismic Design Categories A through F

Included Parts

• EMN22i – One mixing nozzle and extension included with SET3G10 and SET3G22-N

Specifications:

Installation

• Surfaces to receive epoxy must be clean per approved hole cleaning method.
• Base-material temperatures must be 40F (4C) or above at the time of installation. For best results, adhesive should be conditioned to a temperature between 70F (21C) and 80F (37C) at the time of installation.
• To warm cold adhesive, store cartridges in a warm, uniformly heated area or storage container. Do not immerse cartridges in water or use microwave to facilitate warming.
• Mixed material can harden in the dispensing nozzle within 30 minutes at 70F (21C).
• Use only Simpson Strong-Tie mixing nozzles in accordance with Simpson Strong-Tie instructions. Modification or improper use of mixing nozzle may impair SET-3G adhesive performance.
• For full instructions, see Adhesive Anchoring Installation Instructions.

Test Criteria

• SET-3G has been tested in accordance with ICC-ES AC308, ACI 355.4 and applicable ASTM test methods.