Description

Simpson Strong-Tie RCWB14 – 14ft 2″ Rolled Compression Wall Bracing

The RCWB is designed to resist racking during construction and provide long-term strength for structural walls. The RCWB features a rolled edge for extra strength, safety and resistance to in-plane forces, creating an overall stronger structure. While not designed to replace structural panel shearwall load-carrying components, the RCWB is a cost-effective option that fulfills the same code-bracing requirements as a 1×4 let-in brace with a faster install process.

Key Features

• Prevents cosmetic damage, performance problems and structural failure over time
• Helps resist lateral loads resulting from wind and earthquake forces
• Galvanized for corrosion resistance

Material

• 20 gauge

Finish

• Galvanized

Installation

• Use all specified fasteners.
• Use with 16″ o.c. studs.
• Use minimum of 2×6 studs with RCWB (2×4 min. for interior, non-load-bearing wall).
• Establish a run-line using the bracing as a straight edge. Single-cut a saw kerf 1 1/8″ deep along the run line. If the wall is preframed on the floor, place the part into the saw kerf, and put one nail into the top plate. Tilt the wall up and plumb before nailing off the top plate, bottom plate and studs according to the nailing schedule.